242 Alphabetical list of commands
Show port information for a system with two iSCSI ports:
# show host-parameters
Ports Media Target ID Status Speed(A) Speed(C) Health
Health Reason Health Recommendation
-----------------------------------------------------------------------------
A1 iSCSI IQN Up 1Gb Auto OK
IP-Ver PIP PIP-Gateway PIP-Netmask MAC
--------------------------------------------------------------
IPv4 10.134.9.100 10.134.0.1 255.255.0.0 00:C0:FF:29:00:24
A2 iSCSI IQN Disconnected Auto N/A
There is no host connection to this host port. - No action is required.
IP-Ver PIP PIP-Gateway PIP-Netmask MAC
--------------------------------------------------------------
IPv4 10.134.9.101 10.134.0.1 255.255.0.0 00:C0:FF:29:00:23
------------------------------------------------------------------------------
Success: Command completed successfully. (2012-01-18 15:03:55)
Show port information for a system with two SAS ports:
# show host-parameters
Ports Media Target ID Status Speed(A) Health
Health Reason Health Recommendation
-----------------------------------------------------------------------------
A1 SAS WWPN Up Auto OK
Topo(C) Width
--------------
Direct 4
A2 SAS WWPN Disconnected Auto N/A
There is no host connection to this host port. - No action is required.
Topo(C) Width
--------------
Direct 4
-----------------------------------------------------------------------------
Success: Command completed successfully. (2012-01-18 15:04:10)
Basetypes • port
• status
See also • set host-parameters
• show ports
To Next Page
Loading...
