HP P2000 G3 Cli Reference Guide

HP P2000 G3 MSA System CLI Reference Guide 241
PIP-Gateway
iSCSI only. Primary gateway IP address.
PIP-Netmask
iSCSI only. Primary subnet mask IP address.
MAC
iSCSI only. Unique Media Access Control (MAC) hardware address, also called the physical
address.
SIP
iSCSI only. Secondary IP address. This field is only displayed during failover.
SIP-Gateway
iSCSI only. Secondary gateway IP address. This field is only displayed during failover.
SIP-Netmask
iSCSI only. Secondary subnet mask IP address. This field is only displayed during failover.
MAC(S)
iSCSI only. Secondary MAC address. This field is only displayed during failover.
Example Show port information for a system with two FC ports:
# show host-parameters
Ports Media Target ID Status Speed(A) Speed(C) Health
Health Reason Health Recommendation
-----------------------------------------------------------------------------
A1 FC(L) WWPN Up 8Gb Auto OK
OK
Topo(C) PID
------------
Loop 0
A2 FC(-) WWPN Disconnected Auto N/A
There is no host connection to this host port. - No action is required.
Topo(C) PID
------------
Loop 0
-----------------------------------------------------------------------------
Success: Command completed successfully. (2012-01-18 15:03:24)

HP P2000 G3 Specifications

General

Model	P2000 G3
Category	Storage
Drive Support	SAS, SATA
Host Interface	iSCSI, Fibre Channel, SAS
Form Factor	2U
RAID Levels	0, 1, 5, 6, 10
Cache	2 GB
Drive Bays	12 (SFF), 24 (SFF), 12 (LFF)
Cache Memory	2GB per controller
Operating Temperature	10°C to 35°C
Power Supply	Redundant
Expansion Options	Disk Enclosures