HP P2000 G3 Cli Reference Guide

HP P2000 G3 MSA System CLI Reference Guide 279
show schedules
Description Shows information about all task schedules.
Syntax
show schedules
Example Show information about all task schedules:
# show schedules
Schedule Details
----------------
Schedule Name: SnapSched
Schedule Specification: Start 2011-10-19 23:47:00, Every 3 Minutes
Status: Ready
Next Time: 2011-10-19 23:47:00
Task To Run: Snap
Error Message:
Tasks
-----
Task Name: Snap
Task Type: TakeSnapshot
Status: Ready
Task State: Start
Error Message:
Task Details
------------
Source Volume: VD1_V1
Source Volume Serial: SN
Prefix: VD1_V1
Count: 4
Last Created: VD1_V1_S0001
Snapshot Name Snapshot Serial
------------------------------------------------------
VD1_V1_S0001 SN
Schedule Name: bTx_v002_sched1
Schedule Specification: Start 2011-10-03 11:13:00, Every 1 Hours, Count 30
Status: Expired
Next Time: 2011-10-04 17:13:00
Task To Run: bTx_v002_task001
Error Message:
Tasks
-----
Task Name: bTx_v002_task001
Task Type: ReplicateVolume
Status: Ready
Task State: Start
Error Message:
Task Details
------------
Primary Volume Name: bTx_v002
Primary Volume Serial Number: SN
Prefix: bTx_v002_01
Mode: new-snapshot

HP P2000 G3 Specifications

General

Model	P2000 G3
Category	Storage
Drive Support	SAS, SATA
Host Interface	iSCSI, Fibre Channel, SAS
Form Factor	2U
RAID Levels	0, 1, 5, 6, 10
Cache	2 GB
Drive Bays	12 (SFF), 24 (SFF), 12 (LFF)
Cache Memory	2GB per controller
Operating Temperature	10°C to 35°C
Power Supply	Redundant
Expansion Options	Disk Enclosures