HP P2000 G3 Cli Reference Guide

HP P2000 G3 MSA System CLI Reference Guide 351
attribute-priorities
Properties
Example
# show priorities spvd02_v001
...
<OBJECT basetype="attribute-priorities" name="attribute-priorities" oid="1"
format="rows">
<PROPERTY name="attribute-name" type="string">Standard Snapshot</PROPERTY>
<PROPERTY name="priority-value" type="string">0x6000 (default)</PROPERTY>
</OBJECT>
<OBJECT basetype="attribute-priorities" name="attribute-priorities" oid="2"
format="rows">
<PROPERTY name="attribute-name" type="string">Volume Copy Snapshot</PROPERTY>
<PROPERTY name="priority-value" type="string">0xa000 (default)</PROPERTY>
</OBJECT>
<OBJECT basetype="attribute-priorities" name="attribute-priorities" oid="3"
format="rows">
<PROPERTY name="attribute-name" type="string">Replication Snapshot</PROPERTY>
<PROPERTY name="priority-value" type="string">0x4000 (default)</PROPERTY>
</OBJECT>
<OBJECT basetype="attribute-priorities" name="attribute-priorities" oid="4"
format="rows">
<PROPERTY name="attribute-name" type="string">Replicating Snapshot</PROPERTY>
<PROPERTY name="priority-value" type="string">0xc000 (default)</PROPERTY>
</OBJECT>
<OBJECT basetype="attribute-priorities" name="attribute-priorities" oid="5"
format="rows">
<PROPERTY name="attribute-name" type="string">Common Sync Point Snapshot</PROPERTY>
<PROPERTY name="priority-value" type="string">0x8000 (default)</PROPERTY>
</OBJECT>
<OBJECT basetype="attribute-priorities" name="attribute-priorities" oid="6"
format="rows">
<PROPERTY name="attribute-name" type="string">Only Sync Point Snapshot</PROPERTY>
<PROPERTY name="priority-value" type="string">0xe000 (default)</PROPERTY>
Table 10 attribute-priorities properties
Name Type Description
attribute-name string Snapshot retention attribute.
• Standard Snapshot
• Volume Copy Snapshot: A snapshot that is being used to copy data
from a source volume to a destination volume. This attribute is temporary for
the duration of the volume-copy process.
• Replication Snapshot
• Replicating Snapshot: A snapshot that is being replicated to a
secondary volume. This snapshot is required in order to resume the
replication. The attribute is temporary for the duration of the replication
process.
• Common Sync Point Snapshot: The latest snapshot that is copy-
complete on all secondary volumes. It identifies a common point in time that
is known by all destinations.
• Only Sync Point Snapshot: The only sync point that is available on at
least one secondary volume. If this snapshot is removed, then the next
replication requires a full sync to be performed.
• Queued Snapshot: A snapshot that was taken for remote replication but is
queued waiting for the previous replications to complete.
• DRM Snapshot: A temporary standard snapshot created from a replication
snapshot for the purpose of doing a test failover for disaster recovery
management (DRM).
priority-value string Retention priority for the corresponding attribute. Lower-priority snapshots will be
deleted before higher-priority snapshots. Priority values are 1–65535.

HP P2000 G3 Specifications

General

Model	P2000 G3
Category	Storage
Drive Support	SAS, SATA
Host Interface	iSCSI, Fibre Channel, SAS
Form Factor	2U
RAID Levels	0, 1, 5, 6, 10
Cache	2 GB
Drive Bays	12 (SFF), 24 (SFF), 12 (LFF)
Cache Memory	2GB per controller
Operating Temperature	10°C to 35°C
Power Supply	Redundant
Expansion Options	Disk Enclosures