To Next Page

To Previous Page

18 Using the CLI

if( $name eq 'response' ) {

$sessionKey = $prop->textContent;

}

print "Session Key = $sessionKey\n";

# Run a sample command to obtain the disks in the system.

$url = 'http://10.0.0.2/api/show/disks';

$req = HTTP::Request->new(GET => $url);

$req->header('sessionKey' => $sessionKey );

$req->header('dataType' => 'ipa' );

$res = $ua->request($req);

$url2 = 'http://10.0.0.2/api/exit';

$req2 = HTTP::Request->new(GET => $url3);

$req2->header('sessionKey' => $sessionKey );

$req2->header('dataType' => 'api' );

$res2 = $ua->request($req2);

print $res->content;

The next section provides more information about using the XML API.

Using the XML API

The Management Controller provides access for monitoring and management via the Telnet and SSH

protocols for command-line interface semantics, or via the HTTP and HTTPS protocols for XML API

request/response semantics.

You can use an XML parser, such as XML::Parser in Perl, to process the XML output and store this

information as objects. The XML parser should use the Document Type Definition (DTD) version that

corresponds to the firmware level to ensure that the XML is validated. The DTD provides the structure of all

content returned by the CLI when XML API format is enabled. By obtaining the latest DTD for validation, the

parser will be forward compatible. To obtain the DTD, go to http://hp.com/go/p2000

Model

P2000 G3

HP P2000 G3 Cli Reference Guide

Other manuals for HP P2000 G3