HP P2000 G3 MSA System CLI Reference Guide 123
reset snapshot
Description Deletes the data in a standard snapshot and resets it to the current data in the associated master
volume. The snapshot’s volume characteristics are not changed. The command prompts you to
unmount/unpresent/unmap the snapshot from hosts before performing the reset; leaving it mounted
can cause data corruption. This command is not allowed for a replication snapshot.
CAUTION: All data represented by the snapshot as it exists prior to issuing this command is lost.
Syntax
reset snapshot
[prompt yes|no]
volume
Parameters prompt yes|no
Optional. Specifies an automatic response to the prompt to unmount/unpresent/unmap the snapshot
before proceeding:
• yes: Allow the command to proceed.
• no: Cancel the command.
If this parameter is omitted, you must reply to the prompt.
volume
Name or serial number of the snapshot to reset. For volume syntax, see Command syntax on
page 22.
Example Reset snapshot SS1:
# reset snapshot SS1
You MUST unmount the snapshot from all hosts before resetting it.
Ready to continue? yes
Success: Command completed successfully. - The reset of a snapshot completed.
(SS1) - The reset of a snapshot completed. (2012-01-21 13:02:59)
See also • show snapshots
To Next Page
Loading...
Need help?
General
