HP P2000 G3 Cli Reference Guide

42 Alphabetical list of commands
clear expander-status
Description For use by or with direction from a service technician.
Clears the counters and status for SAS expander lanes. Counters and status can be reset to a good
state for all enclosures, or for a specific enclosure whose status is Error as shown by the show
expander-status command.
NOTE: If a rescan is in progress, the clear operation will fail with an error message saying that an
EMP does exist. Wait for the rescan to complete and then retry the clear operation.
Syntax
clear expander-status [enclosure ID]
Parameters enclosure ID
Optional. The enclosure number.
Example Clear the expander status for the first enclosure:
# clear expander-status enclosure 1
Success: Command completed successfully. - Expander status was cleared.
(2012-01-18 14:18:53)
See also • show expander-status

HP P2000 G3 Specifications

General

Model	P2000 G3
Category	Storage
Drive Support	SAS, SATA
Host Interface	iSCSI, Fibre Channel, SAS
Form Factor	2U
RAID Levels	0, 1, 5, 6, 10
Cache	2 GB
Drive Bays	12 (SFF), 24 (SFF), 12 (LFF)
Cache Memory	2GB per controller
Operating Temperature	10°C to 35°C
Power Supply	Redundant
Expansion Options	Disk Enclosures