HP P2000 G3 Cli Reference Guide

234 Alphabetical list of commands
show fans
Description Shows information about each fan in the storage system.
Syntax
show fans
Output Name
Fan name in the form Fan loc:position-PSU power-supply-ID for a controller enclosure or
P2000 drive enclosure; Fan fan-unit-ID for a D2700 or MSA70 enclosure. The position is as
viewed from the back of the enclosure.
Location
Fan location in the form Enclosure enclosure-ID - position. The position is as viewed
from the back of the enclosure.
Status
• Up
• Warning
• Error
• Not Present
• Unknown
Speed
Fan speed (RPM).
Position
Fan position, as viewed from the back of the enclosure:
• Left.
• Right.
• Top.
• Bottom.
Serial Number
• (blank): Not applicable.
• Serial number of a fan in a D2700 enclosure.
Firmware Version
• (blank): Not applicable.
• Firmware revision of a fan in a D2700 enclosure.
Hardware Version
• (blank): Not applicable.
• Hardware revision of a fan in a D2700 enclosure.
Health
• OK
• Degraded
• Fault
• Unknown
Health Reason
If Health is not OK, this field shows the reason for the health state.
Health Recommendation
If Health is not OK, this field shows recommended actions to take to resolve the health issue.

HP P2000 G3 Specifications

General

Model	P2000 G3
Category	Storage
Drive Support	SAS, SATA
Host Interface	iSCSI, Fibre Channel, SAS
Form Factor	2U
RAID Levels	0, 1, 5, 6, 10
Cache	2 GB
Drive Bays	12 (SFF), 24 (SFF), 12 (LFF)
Cache Memory	2GB per controller
Operating Temperature	10°C to 35°C
Power Supply	Redundant
Expansion Options	Disk Enclosures