HP P2000 G3 Cli Reference Guide

80 Alphabetical list of commands
delete remote-system
Description Deletes the persistent association with a remote system.
After establishing replication to a remote system, if you choose to delete the remote system you can
safely do so without affecting replications. However, because the remote system's name and IP
address will no longer appear in user interfaces, record this information before deleting the remote
system so that you can access it at a later time, such as to delete old replication images or for
disaster recovery.
Syntax
delete remote-system system
Parameters system
Name or network-port IP address of the remote system.
Example Delete remote system System2:
# delete remote-system System2
Success: Command deleted successfully. (System2) - The remote system was
deleted. (2012-01-21 12:24:18)
See also • create remote-system
• remote
• set remote-system
• show remote-systems

HP P2000 G3 Specifications

General

Model	P2000 G3
Category	Storage
Drive Support	SAS, SATA
Host Interface	iSCSI, Fibre Channel, SAS
Form Factor	2U
RAID Levels	0, 1, 5, 6, 10
Cache	2 GB
Drive Bays	12 (SFF), 24 (SFF), 12 (LFF)
Cache Memory	2GB per controller
Operating Temperature	10°C to 35°C
Power Supply	Redundant
Expansion Options	Disk Enclosures