HP P2000 G3

HP P2000 G3 MSA System CLI Reference Guide 205
show controller-date
Description Shows the system’s current date and time.
Syntax
show controller-date
Output Controller Date
Date and time in the format year-month-day hour:minutes:seconds.
Time-Zone Offset
The system’s time zone as an offset in hours and minutes from Coordinated Universal Time (UTC).
This is shown only if NTP is enabled.
Example Show the date and time on a system that is using NTP:
# show controller-date
Controller Date: 2012-01-18 14:57:04
Time-Zone Offset: -6:00
Success: Command completed successfully. (2012-01-18 14:57:04)
Basetypes • time-settings-table
• status
See also • set controller-date
• show ntp-status