HP P2000 G3 MSA System CLI Reference Guide 51
create remote-system
Description Creates a persistent association with a remote storage system. This allows a local system to track
remote systems by their network-port IP addresses and cache their login credentials. The IP address
you specify is used to connect to the remote system and obtain information such as the system name
and both controllers' IP addresses. You can then use the system name or an IP address in commands
that need to interact with the remote system.
Syntax
create remote-system
username username
password password
system
Parameters username username
Name of a user on the remote system. This must be a manage-level user to remotely configure or
provision that system.
password password
Password for that user.
system
Network-port IP address of the remote system.
Example Create a remote system:
# create remote-system username manage password !manage 10.122.1.21
Success: Command completed successfully. (10.122.1.21) - The remote system was
created. (2012-01-18 12:10:26)
See also • delete remote-system
• remote
• set remote-system
• show remote-systems
To Next Page
Loading...
Need help?
General
