HP P2000 G3 Cli Reference Guide

HP P2000 G3 MSA System CLI Reference Guide 519
A Settings changed by restore defaults
This appendix summarizes the system settings that result from using the restore defaults command.
Table 99 Settings changed by restore defaults
Setting Value
System information settings:
• System name
• System contact
• System location
• System information
• Uninitialized Name
• Uninitialized Contact
• Uninitialized Location
• Uninitialized Info
Management protocols settings:
• CLI/Telnet
• CLI/SSH
• FTP
• SNMP
• WBI/HTTP
• WBI/HTTPS
• SMI-S
• Unsecure SMI-S
• Debug
• In-band SES
• Enabled
• Enabled
• Enabled
• Enabled
• Enabled
• Enabled
• Enabled
• Disabled
• Disabled
• Enabled
Users All configured users are deleted and replaced with default user definitions
and default settings:
• User: manage; password: !manage
• User: monitor; password: !monitor
• User: ftp; password: !ftp
• Temperature scale: Celsius
• Timeout: 30 minutes
CLI/Telnet timeout 30 minutes
Tasks and schedules (preserved)
1
Remote system definitions (preserved)
2
MC debug logs (preserved)
3
SC event logs (preserved)
Time/date and NTP settings (preserved)
4
Network IP settings If addressing mode is Manual, IP values are preserved. If addressing mode
is DHCP, IP values are released.
5
Network Ethernet-switch settings
• Link speed
• Duplex mode
• Auto-negotiation
• 100mbps
• Full
• Enabled
SNMP settings:
• SNMP
• SNMP trap notification level
• SNMP trap host IPs
• SNMP read community
• SNMP write community
• Disabled
• none
• 0.0.0.0
• public
• private

HP P2000 G3 Specifications

General

Model	P2000 G3
Category	Storage
Drive Support	SAS, SATA
Host Interface	iSCSI, Fibre Channel, SAS
Form Factor	2U
RAID Levels	0, 1, 5, 6, 10
Cache	2 GB
Drive Bays	12 (SFF), 24 (SFF), 12 (LFF)
Cache Memory	2GB per controller
Operating Temperature	10°C to 35°C
Power Supply	Redundant
Expansion Options	Disk Enclosures