HP P2000 G3 Cli Reference Guide

520 Settings changed by restore defaults
SMTP settings:
• Email notification
• Email notify filter
• Email addresses
• Email server
• Email domain
• Email sender
• Log destination
• Include logs
• Disabled
• (none)
• (none)
• (none)
• (none)
• (none)
• (none)
• Disabled
SSL/SSH certificates (preserved)
6
Licenses (preserved)
Vdisk metadata (preserved)
Host port settings:
• FC link speed
• FC topology
• Auto
• Auto
Host names and profiles (preserved)
7
Drive spin down Disabled
Advanced settings:
• Vdisk background scrub
• Partner firmware upgrade
• Utility priority
• SMART
• Dynamic spare configuration
• Enclosure polling rate
• Supercap failure
• CompactFlash failure
• Auto write back
• Disk background scrub
• Enabled
• Enabled
• High
• (preserved)
8
• Disabled
• 5 seconds
• Enabled
• Enabled
• Enabled
• Disabled
Native Command Queuing (NCQ) Enabled
Managed Logs Disabled
1. Factory default: no tasks or schedules.
2. Factory default: no remote system definitions.
3. Factory default: MC logs are cleared.
4. Factory default: NTP is disabled; NTP host IP address is 0.0.0.0; NTP offset is 0.
5. Factory default: IP addresses are released.
6. Factory default: certificates are initialized.
7. Factory default: host names and profiles are cleared.
8. Factory default: no action for all disks.
Table 99 Settings changed by restore defaults (continued)
Setting Value

HP P2000 G3 Specifications

General

Model	P2000 G3
Category	Storage
Drive Support	SAS, SATA
Host Interface	iSCSI, Fibre Channel, SAS
Form Factor	2U
RAID Levels	0, 1, 5, 6, 10
Cache	2 GB
Drive Bays	12 (SFF), 24 (SFF), 12 (LFF)
Cache Memory	2GB per controller
Operating Temperature	10°C to 35°C
Power Supply	Redundant
Expansion Options	Disk Enclosures