HP P2000 G3

HP P2000 G3 MSA System CLI Reference Guide 289
show snmp-parameters
Description Shows SNMP settings for event notification.
Syntax
show snmp-parameters
Output SNMP Trap Notification Level
• crit: Only Critical events are sent as traps.
• error: Error and Critical events are sent as traps.
• warn: Warning, Error, and Critical events are sent as traps.
• info: All events are sent as traps.
• none: No events are sent as traps and traps are disabled.
SNMP Trap Host IP#
IP address of each trap host.
SNMP read community
Community string for read-only access (not shown to Monitor users).
SNMP write community
Community string for write access (not shown to Monitor users).
Example Show SNMP notification settings:
# show snmp-parameters
SNMP Trap Notification Level: crit
SNMP Trap Host IP1: 172.22.4.171
SNMP Trap Host IP2: 0.0.0.0
SNMP Trap Host IP3: 0.0.0.0
SNMP read community: public
SNMP write community: private
Success: Command completed successfully. (2012-01-19 15:27:59)
Basetypes • snmp-parameters
• status
See also • set snmp-parameters
• set protocols
• show protocols