HP P2000 G3 Cli Reference Guide

HP P2000 G3 MSA System CLI Reference Guide 261
show priorities
Description Shows snapshot-retention priorities for a specified snap pool. Snap-pool priorities, in conjunction
with snapshot priorities, determine which snapshots are retained if system resource limitations require
some snapshots to be automatically deleted.
Lower-priority snapshots will be deleted before higher-priority snapshots. Priority values are
0–65535.
Syntax
show priorities snap-pool
Parameters snap-pool
Name or serial number of the snap pool.
Output Attribute Name
• Standard Snapshot
• Volume Copy Snapshot: A snapshot that is being used to copy data from a source volume to
a destination volume. This attribute is temporary for the duration of the volume-copy process.
• Replication Snapshot
• Replicating Snapshot: A snapshot that is being replicated to a secondary volume. This
snapshot is required in order to resume the replication. The attribute is temporary for the duration
of the replication process.
• Common Sync Point Snapshot: The latest snapshot that is copy-complete on all secondary
volumes. It identifies a common point in time that is known by all destinations.
• Only Sync Point Snapshot: The only sync point that is available on at least one secondary
volume. If this snapshot is removed, then the next replication requires a full sync to be performed.
• Queued Snapshot: A snapshot that was taken for remote replication but is queued waiting for
the previous replications to complete.
• DRM Snapshot: A temporary standard snapshot created from a replication snapshot for the
purpose of doing a test failover for disaster recovery management (DRM).
Priority
Retention priority for the corresponding attribute.
Example Show priorities for snap-pool SP1:
# show priorities SP1
Attribute Name Priority
-----------------------------------------------
Standard Snapshot 0x6000 (default)
Volume Copy Snapshot 0xa000 (default)
Replication Snapshot 0x4000 (default)
Replicating Snapshot 0xc000 (default)
Common Sync Point Snapshot 0x8000 (default)
Only Sync Point Snapshot 0xe000 (default)
Queued Snapshot 0x2000 (default)
DRM Snapshot 0xb000 (default)
-----------------------------------------------
Success: Command completed successfully. (2012-01-18 15:11:03)
Basetypes • attribute-priorities
• status
See also • set priorities
• show snap-pools

HP P2000 G3 Specifications

General

Model	P2000 G3
Category	Storage
Drive Support	SAS, SATA
Host Interface	iSCSI, Fibre Channel, SAS
Form Factor	2U
RAID Levels	0, 1, 5, 6, 10
Cache	2 GB
Drive Bays	12 (SFF), 24 (SFF), 12 (LFF)
Cache Memory	2GB per controller
Operating Temperature	10°C to 35°C
Power Supply	Redundant
Expansion Options	Disk Enclosures