138 Alphabetical list of commands
set awt
See set auto-write-through-trigger.
partner-notify enabled|disabled|on|off
Optional. Sets whether to notify the partner controller that a trigger condition occurred. Enable this
option to have the partner also change to write-through mode for better data protection. Disable this
option to allow the partner to continue using its current caching mode for better performance.
• disabled or off: Notification is disabled. This is the default.
• enabled or on: Notification is enabled.
auto-write-back enabled|disabled|on|off
Optional. Sets whether the cache mode will change from write-through to write-back when the
trigger condition is cleared.
• disabled or off: Auto-write-back is disabled.
• enabled or on: Auto-write-back is enabled. This is the default.
Example Enable the controller-failure trigger and disable the partner-notification trigger:
# set auto-write-through-trigger controller-failure enabled partner-notify
disabled
Success: Command completed successfully. - Auto-write-through-trigger parameters
were changed. (2012-01-21 11:50:05)
See also • show auto-write-through-trigger
• show events
To Next Page
Loading...
