HP P2000 G3 Cli Reference Guide

HP P2000 G3 MSA System CLI Reference Guide 319
show volume-names
Description Shows volume names and serial numbers. This reduced form of the show volumes command is
optimized for seeking basic volume information from a remote system.
Syntax
show volume-names [volumes]
Parameters volumes
Optional. Names or serial numbers of the volumes to show information about. For volume syntax,
see Command syntax on page 22. If this parameter is omitted, information is shown for all volumes.
Output Name
Name of the volume.
Serial Number
Volume serial number.
Example Show volume names and serial numbers:
# show volume-names
Name Serial Number
------------------------
Data SN
Data_s001 SN
spData SN
vd1_v1 SN
------------------------
Success: Command completed successfully. (2012-01-19 15:34:14)
Basetypes • volume-names
• status
See also • show volume-maps
• show volumes

HP P2000 G3 Specifications

General

Model	P2000 G3
Category	Storage
Drive Support	SAS, SATA
Host Interface	iSCSI, Fibre Channel, SAS
Form Factor	2U
RAID Levels	0, 1, 5, 6, 10
Cache	2 GB
Drive Bays	12 (SFF), 24 (SFF), 12 (LFF)
Cache Memory	2GB per controller
Operating Temperature	10°C to 35°C
Power Supply	Redundant
Expansion Options	Disk Enclosures