HP P2000 G3 Cli Reference Guide

HP P2000 G3 MSA System CLI Reference Guide 143
pager enabled|on|disabled|off
Optional.
• enabled or on: Halts output after each full screen to wait for keyboard input. This is the default.
• disabled or off: Output is not halted. When displaying output in XML API format, which is
intended for scripting, disable paging.
precision #
Optional. Sets the number of decimal places (1–10) for display of storage-space sizes. The default is
1.
storage-size-base 2|10
Optional. Alias for base.
storage-size-precision #
Optional. Alias for precision.
storage-size-units auto|MB|GB|TB
Optional. Alias for units.
temperature-scale celsius|c|fahrenheit|f
Optional. Sets the scale for display of temperature values:
• fahrenheit or f: Temperatures are shown in degrees Fahrenheit.
• celsius or c: Temperatures are shown in degrees Celsius. This is the default.
timeout #
Optional. Sets the timeout value in seconds for the login session. Valid values are 120–43200
seconds (2–720 minutes). The default is 1800 seconds (30 minutes).
units auto|MB|GB|TB
Optional. Sets the unit for display of storage-space sizes:
• auto: Sizes are shown in units determined by the system. This is the default.
• MB: Sizes are shown in megabytes.
• GB: Sizes are shown in gigabytes.
• TB: Sizes are shown in terabytes.
Based on the precision setting, if a size is too small to meaningfully display in the selected unit,
the system uses a smaller unit for that size. For example, if units is set to TB, precision is set to
1, and base is set to 10, the size 0.11709 TB is instead shown as 117.1 GB.
Example Set CLI parameters:
# set cli-parameters timeout 600 precision 2 units GB temperature-scale f
Success: Command completed successfully. - The settings were changed
successfully. (2012-01-21 11:56:08)
For scripting, display XML output in api-embed format and disable paging:
# set cli-parameters api-embed pager off
For scripting, display brief XML output in api-embed format and disable paging:
# set cli-parameters api-embed pager off brief on
Set CLI to show output in console format:
# set cli-parameters console
Success: Command completed successfully. - The settings were changed
successfully. (2012-01-21 11:56:17)
See also • show cli-parameters

HP P2000 G3 Specifications

General

Model	P2000 G3
Category	Storage
Drive Support	SAS, SATA
Host Interface	iSCSI, Fibre Channel, SAS
Form Factor	2U
RAID Levels	0, 1, 5, 6, 10
Cache	2 GB
Drive Bays	12 (SFF), 24 (SFF), 12 (LFF)
Cache Memory	2GB per controller
Operating Temperature	10°C to 35°C
Power Supply	Redundant
Expansion Options	Disk Enclosures