HP P2000 G3 Cli Reference Guide

HP P2000 G3 MSA System CLI Reference Guide 149
Example Set the system to send an email from RAIDsystem@mydomain.com to both
sysadmin@mydomain.com and JSmith@domain2.com when a non-Informational event occurs,
and to send an email with attached logs to logcollector@mydomain.com when logs need to
be transferred:
# set email-parameters server 10.1.1.10 sender RAIDsystem domain mydomain.com
notification-level warn include-logs enabled email-list
sysadmin@mydomain.com,JSmith@domain2.com,,logcollector@mydomain.com
Info: Set Email Address 1 to: sysadmin@mydomain.com (sysadmin@mydomain.com)
Info: Set Email Address 2 to: JSmith@domain2.com (sysadmin@mydomain.com)
Info: Set Email Address 3 to:
Info: Set Email Address 4 to: logcollector@mydomain.com
(logcollector@mydomain.com)
Info: Set Email Server Name to: 10.1.1.10 (10.1.1.10)
Info: Set Email Domain Name to: mydomain.com (mydomain.com)
Info: Set Email Notification Level to: warn (mydomain.com)
Info: Set Email Sender Name to: RAIDsystem (RAIDsystem)
Info: Set Email Include Logs: enabled (enabled)
Success: Command completed successfully. (2012-01-21 15:07:46)
See also • show email-parameters
• test

HP P2000 G3 Specifications

General

Model	P2000 G3
Category	Storage
Drive Support	SAS, SATA
Host Interface	iSCSI, Fibre Channel, SAS
Form Factor	2U
RAID Levels	0, 1, 5, 6, 10
Cache	2 GB
Drive Bays	12 (SFF), 24 (SFF), 12 (LFF)
Cache Memory	2GB per controller
Operating Temperature	10°C to 35°C
Power Supply	Redundant
Expansion Options	Disk Enclosures