HP P2000 G3 Cli Reference Guide

HP P2000 G3 MSA System CLI Reference Guide 157
On a system with FC ports, set the link speed to 4 Gbit/sec for ports A1 and B1; set controller A
ports to request loop ID 5 and controller B ports to request loop ID 32; and suppress the confirmation
prompt:
# set host-parameters speed 4g ports a1,b1 fibre-loop-id 5,32 noprompt
Info: Changes to FC loop IDs will not take effect until the affected Storage
Controller is rebooted.
Success: Command completed successfully. - The host parameters were changed
successfully. (2012-01-21 15:46:14)
On a system with iSCSI ports, for port A3 change the IP address:
# set host-parameters ip 10.134.50.6 port a3 iscsi-ip-version ipv4
WARNING: This change will take effect immediately. Changes may affect access to
data. Are you sure? yes
Success: Command completed successfully. - The host parameters were changed
successfully. (2012-01-21 15:46:51)
Specify that iSCSI ports will use IPv6 addressing:
# set host-parameters iscsi-ip-version ipv6
Success: Command completed successfully. - iSCSI parameter(s) were changed
successfully. (2012-01-21 15:47:30)
See also • restart
• set iscsi-parameters
• show host-parameters

HP P2000 G3 Specifications

General

Model	P2000 G3
Category	Storage
Drive Support	SAS, SATA
Host Interface	iSCSI, Fibre Channel, SAS
Form Factor	2U
RAID Levels	0, 1, 5, 6, 10
Cache	2 GB
Drive Bays	12 (SFF), 24 (SFF), 12 (LFF)
Cache Memory	2GB per controller
Operating Temperature	10°C to 35°C
Power Supply	Redundant
Expansion Options	Disk Enclosures