HP P2000 G3 Cli Reference Guide

HP P2000 G3 MSA System CLI Reference Guide 185
Example Change parameters for a TakeSnapshot-type task named Snap:
# set task snapshot-prefix VD1v1 retention-count 2 Snap
Success: Command completed successfully. (Snap) - The task was
modified.(2012-01-21 12:37:49)
Change parameters for a VolumeCopy-type task named Copy:
# set task dest-vdisk VD3 dest-prefix VD1v1 modified-snapshot no Copy
Success: Command completed successfully. (Copy) - The task was
modified.(2012-01-21 12:37:52)
Change parameters for a ReplicateVolume-type task named Replicate:
# set task snapshot-prefix VD1v2 replication-mode last-snapshot Replicate
Success: Command completed successfully. (Replicate) - The task was
modified.(2012-01-21 12:37:57)
See also • create task
• delete task
• set schedule
• show schedule-details
• show schedules
• show task-details
• show tasks

HP P2000 G3 Specifications

General

Model	P2000 G3
Category	Storage
Drive Support	SAS, SATA
Host Interface	iSCSI, Fibre Channel, SAS
Form Factor	2U
RAID Levels	0, 1, 5, 6, 10
Cache	2 GB
Drive Bays	12 (SFF), 24 (SFF), 12 (LFF)
Cache Memory	2GB per controller
Operating Temperature	10°C to 35°C
Power Supply	Redundant
Expansion Options	Disk Enclosures