208 Alphabetical list of commands
Example Show controller information:
# show controllers
Controllers
-----------
Controller ID: A
Serial Number: SN
Hardware Version: 25
CPLD Version: 8
MAC Address: 00:C0:FF:27:50:24
WWNN: WWNN
IP Address: 10.134.11.100
IP Subnet Mask: 255.255.0.0
IP Gateway: 10.134.0.1
Disks: 17
Vdisks: 2
Cache Memory Size (MB): 1024
Host Ports: 4
Disk Channels: 2
Disk Bus Type: SAS
Status: Operational
Failed Over to This Controller: No
Fail Over Reason: Not applicable
Health: OK
Health Reason:
Health Recommendation:
Position: Top
Phy Isolation: Enabled
Controller Redundancy Mode: Active-Active ULP
Controller Redundancy Status: Redundant
Controllers
-----------
Controller ID: B
...
Success: Command completed successfully. (2012-01-18 14:58:54)
Basetypes • controllers
• status
See also • show configuration
• show frus
To Next Page
Loading...
