HP P2000 G3

254 Alphabetical list of commands
Example Show network parameters for a storage system using DHCP:
# show network-parameters
Network Parameters Controller A
-------------------------------
IP Address: 10.134.129.188
Gateway: 10.134.0.1
Subnet Mask: 255.255.0.0
MAC Address: value
Addressing Mode: DHCP
Link Speed: Unknown
Duplex Mode: Undefined
Auto Negotiation: Disabled
Health: OK
Health Reason:
Health Recommendation:
Network Parameters Controller B
-------------------------------
IP Address: 10.134.129.189
Gateway: 10.134.0.1
Subnet Mask: 255.255.0.0
MAC Address: value
Addressing Mode: DHCP
Link Speed: Unknown
Duplex Mode: Undefined
Auto Negotiation: Disabled
Health: OK
Health Reason:
Health Recommendation:
Success: Command completed successfully. (2012-10-29 15:09:03)
Show network parameters for a storage system using manual addressing:
# show network-parameters
Network Parameters Controller A
-------------------------------
IP Address: 172.22.1.200
Gateway: 172.22.1.1
Subnet Mask: 255.255.255.0
MAC Address: value
Addressing Mode: Manual
...
Network Parameters Controller B
-------------------------------
IP Address: 172.22.1.201
Gateway: 172.22.1.1
Subnet Mask: 255.255.255.0
MAC Address: value
Addressing Mode: Manual
...