HP P2000 G3 Cli Reference Guide

264 Alphabetical list of commands
From either controller, show the redundancy status of a dual-controller system where controller B is
down:
# show redundancy-mode
System Redundancy
-----------------
Controller Redundancy Mode: Fail Over
Controller Redundancy Status: Operational but not redundant
Controller A Status: Operational
Controller A Serial Number: SN
Controller B Status: Down
Controller B Serial Number: SN
Success: Command completed successfully. (2012-02-01 11:03:39)
From either controller, show the redundancy status of a dual-controller system where both controllers
are down:
# show redundancy-mode
System Redundancy
-----------------
Controller Redundancy Mode: Down
Controller Redundancy Status: Down
Controller A Status: Down
Controller A Serial Number: SN
Controller B Status: Down
Controller B Serial Number: SN
Success: Command completed successfully. (2012-02-01 11:03:39)
Show the redundancy status of a single-controller system:
# show redundancy-mode
System Redundancy
-----------------
Controller Redundancy Mode: Single Controller
Controller Redundancy Status: Operational but not redundant
Controller A Status: Operational
Controller A Serial Number: SN
Controller B Status: Not installed
Controller B Serial Number: Not Available
Success: Command completed successfully. (2011-09-22 13:21:05)
Basetypes • redundancy
• status

HP P2000 G3 Specifications

General

Model	P2000 G3
Category	Storage
Drive Support	SAS, SATA
Host Interface	iSCSI, Fibre Channel, SAS
Form Factor	2U
RAID Levels	0, 1, 5, 6, 10
Cache	2 GB
Drive Bays	12 (SFF), 24 (SFF), 12 (LFF)
Cache Memory	2GB per controller
Operating Temperature	10°C to 35°C
Power Supply	Redundant
Expansion Options	Disk Enclosures