HP P2000 G3 Cli Reference Guide

HP P2000 G3 MSA System CLI Reference Guide 27
System
configuration
and utilities
clear cache
create certificate
create chap-record
delete chap-records
ping
reset host-link
restart
set advanced-settings
set auto-write-through-trigger
set awt
set chap-record
set controller-date
set disk-parameters
set enclosure
set expander-fault-isolation
set expander-phy
set host-parameters
set iscsi-parameters
set job-parameters
set led
set network-parameters
set ntp-parameters
set protocols
set system
show advanced-settings
show auto-write-through-trigger
show awt
show certificate
show chap-records
show configuration
show controller-date
show controllers
show disk-parameters
show enclosures
show enclosure-status
show expander-status
show fans
show frus
show host-parameters
show inquiry
show iscsi-parameters
show job-parameters
show license
show network-parameters
show ntp-status
show ports
show power-supplies
show protocols
show redundancy-mode
show sas-link-health
show sensor-status
show shutdown-status
show system
show system-parameters
show versions
shutdown
versions
Service
utilities
clear events
clear expander-status
reset smis-configuration
restore defaults
set debug-log-parameters
set expander-fault-isolation
set expander-phy
show debug-log-parameters
show expander-status
API specific meta show refresh-counters
Remote
systems
create remote-system
delete remote-system
remote
set remote-system
show remote-systems
verify links
verify remote-link
Table 7 Commands by category (continued)
Category Commands

HP P2000 G3 Specifications

General

Model	P2000 G3
Category	Storage
Drive Support	SAS, SATA
Host Interface	iSCSI, Fibre Channel, SAS
Form Factor	2U
RAID Levels	0, 1, 5, 6, 10
Cache	2 GB
Drive Bays	12 (SFF), 24 (SFF), 12 (LFF)
Cache Memory	2GB per controller
Operating Temperature	10°C to 35°C
Power Supply	Redundant
Expansion Options	Disk Enclosures