HP P2000 G3 Cli Reference Guide

HP P2000 G3 MSA System CLI Reference Guide 271
On Error
Error policy to invoke when errors occur during the replication process: Retry or Suspend.
Link Type
Type of ports used to link the primary and secondary volumes:
• FC: FC ports.
• iSCSI: iSCSI ports.
On Collision
Collision policy used to determine the next image to replicate when multiple replication images are
queued: Newest or Oldest.
Monitor Interval
Interval in seconds at which the primary volume should query the secondary volume.
Priority
Priority of the replication process on the replication volume: Low, Medium, or High.
Connection Status
• Not Attempted: Communication has not been attempted to the remote volume.
• Online: The volumes in the replication set have a valid connection but communication is not
currently active.
• Active: Communication is currently active to the remote volume.
• Offline: No connection is available to the remote system.
Connection Time
Date and time of the last communication with the remote volume, or N/A.
Remote link information:
Connected Ports
• For a remote primary or secondary volume, this field shows the IDs of up to two hosts ports in the
local system that are connected to the remote system. If two ports are connected but only one is
shown, this indicates that a problem is preventing half the available bandwidth from being used.
• For a local primary or secondary volume, this field shows N/A.
Remote Address
The address of each host port in the remote system through which the volume is accessible.
Example Show information about all replication sets:
# show replication-sets
Replication Set [Name (rsvd01_v001) Serial Number (SN) ] Primary Volume:
Name Serial Number Status Status-Reason Monitor Location
Primary-Volume Primary-Volume-Serial Primary-Volume-Status MaxQueue
MaxRetryTime On Error Link Type On Collision Monitor Interval
Priority Connection Status Connection Time
-----------------------------------------------------------------------------
vd01_v001 SN Online N/A OK Remote
vd01_v001 SN Online 32
1800 Retry iSCSI Oldest 300
Medium Online 2012-01-18 10:04:00
Connected Ports Remote Address
--------------------------------------------------------------
A1 IP=10.134.9.46:3260
IP=10.134.9.47:3260
IP=10.134.9.48:3260
A1 IP=10.134.9.49:3260

HP P2000 G3 Specifications

General

Model	P2000 G3
Category	Storage
Drive Support	SAS, SATA
Host Interface	iSCSI, Fibre Channel, SAS
Form Factor	2U
RAID Levels	0, 1, 5, 6, 10
Cache	2 GB
Drive Bays	12 (SFF), 24 (SFF), 12 (LFF)
Cache Memory	2GB per controller
Operating Temperature	10°C to 35°C
Power Supply	Redundant
Expansion Options	Disk Enclosures