HP P2000 G3 Cli Reference Guide

HP P2000 G3 MSA System CLI Reference Guide 277
Example Show the condition of SAS port connections in a two-enclosure system:
# show sas-link-health
Encl Ctlr Name Status Health
Health Reason Health Recommendation
-----------------------------------------------------------------------------
1 A Out Port Up OK
1 B Out Port Up OK
-----------------------------------------------------------------------------
Encl Ctlr Name Status Health
Health Reason
Health Recommendation
-----------------------------------------------------------------------------
2 A Out Port Disconnected N/A
No drive enclosure is connected to this expansion port. This is normal if
this is the last (or only) enclosure in the cabling sequence of the system.
- No action is required.
2 A In Port Up OK
2 B Out Port Disconnected N/A
No drive enclosure is connected to this expansion port. This is normal if
this is the last (or only) enclosure in the cabling sequence of the system.
- No action is required.
2 B In Port Up OK
-----------------------------------------------------------------------------
Success: Command completed successfully. (2012-01-19 10:10:13)
Basetypes • expander-ports
• status

HP P2000 G3 Specifications

General

Model	P2000 G3
Category	Storage
Drive Support	SAS, SATA
Host Interface	iSCSI, Fibre Channel, SAS
Form Factor	2U
RAID Levels	0, 1, 5, 6, 10
Cache	2 GB
Drive Bays	12 (SFF), 24 (SFF), 12 (LFF)
Cache Memory	2GB per controller
Operating Temperature	10°C to 35°C
Power Supply	Redundant
Expansion Options	Disk Enclosures