HP P2000 G3 Cli Reference Guide

HP P2000 G3 MSA System CLI Reference Guide 297
Task State
Current step of the task:
• Start
• VerifyVolume
• CreateName
• ObtainMap
• UnmapVolume
• CreateVolume
• RemapVolume
• VerifyCreatedVolume
Error Message
Message if an error occurred while processing the task, or blank.
Source Volume
Name of the volume to be copied.
Source Volume Serial
Serial number of the volume to be copied.
Destination Vdisk
Name of the destination vdisk.
Destination Vdisk Serial
Serial number of the destination vdisk.
Prefix
Label that identifies copies created by this task. Volume names have the format prefix_c#, where
# starts at 001.
Modified Data
• modified: The copy includes modified snapshot data.
• preserved: The copy excludes modified snapshot data.
Last Created
Name of the last volume created by the task, or blank.
For a ReplicateVolume task:
Task Name
Task name.
Task Type
ReplicateVolume
Status
• Uninitialized: Task is not yet ready to run.
• Ready: Task is ready to run.
• Active: Task is running.
• Error: Task has an error.
• Invalid: Task is invalid.

HP P2000 G3 Specifications

General

Model	P2000 G3
Category	Storage
Drive Support	SAS, SATA
Host Interface	iSCSI, Fibre Channel, SAS
Form Factor	2U
RAID Levels	0, 1, 5, 6, 10
Cache	2 GB
Drive Bays	12 (SFF), 24 (SFF), 12 (LFF)
Cache Memory	2GB per controller
Operating Temperature	10°C to 35°C
Power Supply	Redundant
Expansion Options	Disk Enclosures