HP P2000 G3

HP P2000 G3 MSA System CLI Reference Guide 299
For a DisableDSD task:
Task Name
Task name, which must be taskDSDsuspend
Task Type
DisableDSD
Status
• Uninitialized: Task is not yet ready to run.
• Ready: Task is ready to run.
• Active: Task is running.
• Error: Task has an error.
• Invalid: Task is invalid.
Task State
Current step of the task; always Start
Error Message
Message if an error occurred while processing the task, or blank.
Example Show information about task Snap:
# show task-details Snap
Tasks
-----
Task Name: Snap
Task Type: TakeSnapshot
Status: Ready
Task State: Start
Error Message:
Task Details
------------
Source Volume: MV
Source Volume Serial: SN
Prefix: MV
Count: 1
Last Created: MV_S0001
Snapshot Name Snapshot Serial
------------------------------------------------------
MV_S0001 SN
Success: Command completed successfully. (2012-10-19 15:28:33)
Basetypes • tasks
• status
See also • create schedule
• create task
• delete task
• set task
• show schedule-details
• show schedules
• show tasks