HP P2000 G3 MSA System CLI Reference Guide 37
Example Add secondary volume MV2 to the replication set whose primary volume is MV1; set the replication
priority to high; and allow a maximum of 2 queued images to be considered for replication:
# add replication-volume link-type FC secondary-address
wwpn=207000c0ffd52c31,217000c0ff52c31 primary-volume MV1 priority high max-queue
2 MV2
Info: Started adding the secondary volume to the replication set. (MV2)
Info: Verifying that the secondary volume was added to the replication set. This
may take a couple of minutes... (MV2)
Info: The secondary volume was added to the replication set. (MV2)
Success: Command completed successfully. (2012-01-21 17:37:40)
Add secondary volume LosAngeles to a replication set that uses iSCSI links and whose primary
volume is NewYork:
# add replication-volume LosAngeles primary-volume NewYork link-type iSCSI
secondary-address ip=10.134.69.5,10.134.69.6
See also • show replication-sets
• show replication-volumes
To Next Page
Loading...
