HP ProCurve 5400zl User Manual

Specify the IP address the request is for.
Next Available Options:
■ area -- Specify an OSPF area.(p. 221)
■ cost < 1 to 65535 > -- Set metric of this interface.(p. 229)
■ [no] interface vlan VLAN-ID ip address IP-ADDR/mask-LENGTH
Interface IP address/mask.
■ [no] interface vlan VLAN-ID ip bootp-gateway IP-ADDR
IPv4 address of the BOOTP gateway.
■ [no] interface vlan VLAN-ID ip forward-protocol udp IP-ADDR
IP address of the protocol server.
Next Available Options:
■ port-num -- UDP port number of the server. (TCP/UDP-PORT) (p. 263)
■ port-name < dns | ntp | netbios-ns | ... > -- (NUMBER) (p. 263)
■ [no] interface vlan VLAN-ID ip ospf IP-ADDR
Specify the IP address the request is for.
Next Available Options:
■ passive -- Configures an ospf interface as passive. (p. 258)
■ area -- Specify an OSPF area.(p. 221)
■ authentication-key -- Set simple authentication method and key.(p. 223)
■ authentication -- Disable authentication.(p. 223)
■ md5-auth-key-chain -- Set MD5 authentication method and key chain.(p. 250)
■ cost < 1 to 65535 > -- Set metric of this interface.(p. 229)
■ dead-interval < 1 to 65535 > -- Set dead interval in seconds; the default is 40.(p. 229)
■ hello-interval < 1 to 65535 > -- Set hello interval in seconds; the default is 10.(p. 236)
■ priority < 0 to 255 > -- Set priority of this router as a designated router.(p. 265)
■ retransmit-interval < 1 to 3600 > -- Set retransmit interval in seconds; the default is 5.(p. 273)
■ transit-delay < 1 to 3600 > -- Set transit delay in seconds; the default is 1.(p. 279)
■ [no] interface vlan VLAN-ID ip rip IP-ADDR
Specify the IP address the request is for.
Next Available Options:
■ authentication-type < none | text > -- Set authentication type used on this interface.(p. 224)
■ authentication-key -- Set RIP authentication key (maximum 16 characters).(p. 223)
■ metric < 1 to 15 > -- Set metric for this interface.(p. 250)
■ poison-reverse -- Enable/disable poison reverse on this interface.(p. 262)
■ receive < V1-only | V2-only | V1-or-V2 | ... > -- Define RIP version for incoming packets.(p. 273)
■ send < disabled | V1-only | V1-compatible-V2 | ... > -- Define RIP version for outgoing packets.(p.
275)
■ rip-compatible < V1-only | V2-only | V1-or-V2 > -- Define RIP version for incoming and outgoing
packets.(p. 274)
242© 2009 Hewlett-Packard Development Company, L.P.
interfaceCommand Line Interface Reference Guide

HP ProCurve 5400zl Specifications

General

Brand	HP
Model	ProCurve 5400zl
Category	Switch
Language	English