Next Available Option:
â– link-local -- Configure a link-local IPv6 address.(p. 733)
ipv6-addr/mask
â– [no] vlan VLAN-ID ipv6 address IPV6-ADDR/PREFIX-LEN
Conîš¿gure IPv6 address represented in CIDR notation.
Next Available Options:
â– anycast -- Address that is assigned to a set of interfaces that typically belong to different
nodes(p. 716)
â– eui-64 -- An IPv6 EUI-64 address that can be automatically configured on any interface(p. 723)
irdp
â– [no] vlan VLAN-ID ip irdp
Usage: [no] ip irdp [...]
Description: Conîš¿gure ICMP Router Discovery Protocol (IRDP). This is
a VLAN context command. It can be called directly from the VLAN
context or may follow the 'vlan VLAN-ID' command preîš¿x.
Called without parameters the command enables or disables (if
preceded by 'no') the protocol on the VLAN speciîš¿ed, or
identiîš¿ed by the current VLAN context. Use 'ip irdp ?' to get
a list of all possible conîš¿gurable parameters.
Next Available Options:
â– advert-address < multicast | broadcast > -- Specify the destination address to be used for router
advertisements(p. 714)
â– holdtime < 4 to 9000 > -- Set the lifetime (in seconds) of the router advertisements sent on this
interface(p. 726)
â– maxadvertinterval < 4 to 1800 > -- Set the maximum time (in seconds) allowed between sending
unsolicited router advertisements(p. 733)
â– minadvertinterval < 3 to 1800 > -- Set the minimum time (in seconds) allowed between sending
unsolicited router advertisements(p. 735)
â– preference -- The preferability of the router as a default router, relative to the other routers on
the same subnet(p. 742)
jumbo
â– [no] vlan VLAN-ID jumbo
Usage: [no] jumbo
Description: Labels this VLAN as a Jumbo VLAN, allowing you to pass
packets up to 9220 bytes in size.
This is a VLAN context command. It can be called directly
from the VLAN context or follow the 'vlan VLAN-ID'
command.
732© 2009 Hewlett-Packard Development Company, L.P.
vlanCommand Line Interface Reference Guide
To Next Page
Loading...
Need help?
General