HP ProLiant ML310 Setup And Installation Guide

Troubleshooting
4. Restart the server.
5. Check for the following normal power-up sequence to be sure that the server
meets the minimal hardware requirements and is powered up under normal
operation:
a. The front panel Power On/Standby LED turns green.
b. The fans start up.
c. The monitor displays messages regarding server initialization in the
following sequence:
Video initialization—The initialization screen is displayed.
Processor initialization
Memory test
Memory initialization
Diskette drive
SCSI devices (if applicable)
ATA devices (if applicable)
Option ROM
d. The operating system loads to complete the boot process.
If the problem persists, continue with the section, “Diagnosis Steps,” in this
appendix.
D-4 HP ProLiant ML310 Server Setup and Installation Guide
HP CONFIDENTIAL
Writer: Ted Weiman File Name: k-appd.doc
Codename: Son of Beast Part Number: 274431-002 Last Saved On: 11/22/02 2:09 PM

HP ProLiant ML310 Specifications

General

Form Factor	Tower
Processor Sockets	1
Maximum Memory	32GB
Memory Slots	4
Storage Controller	HP Dynamic Smart Array B120i
Processor	Intel Xeon E3-1200 series
Memory Type	DDR3
RAID Support	RAID 0, 1, 10
Storage	Up to 4 LFF (3.5-inch) drives
Hard Drive Interface	SATA
Network	1Gb Ethernet
Power Supply	350W
Operating System Support	Red Hat Enterprise Linux, SUSE Linux Enterprise Server
Expansion Slots	1 x PCIe 2.0 x1