E
LED Indicators, Switches, and Jumpers
This appendix provides information on LED statuses, switch settings, and jumper
settings for ProLiant ML310 servers.
This appendix includes the following topics:
LEDs There are several LEDs located on the front, the back, and the
inside of the server. These LEDs communicate the status of the
server components and operations, thus aiding you in diagnosing
the problem. This appendix provides you with an illustration of
the location of each LED on the server, as well as an explanation
of uses and possible statuses.
·
·
·
Switches There are two switchbanks in the server. Some switch settings
may need to be changed from time to time and can cause
problems if they are not correctly set. Some switches should not
be changed for any reason. This appendix provides you with a
description of what each setting means, and an illustration of
where the switches are found inside the server.
Jumpers When devices are added to the server, the jumpers on the device
may need to be changed. This appendix provides you with
information on jumper settings for both SCSI and ATA devices.
For information beyond the scope of this guide, both general and specific to the
server, refer to “Other Information Resources” in Appendix D.
HP ProLiant ML310 Server Setup and Installation Guide E-1
HP CONFIDENTIAL
Writer: Ted Weiman File Name: l-appe.doc
Codename: Son of Beast Part Number: 274431-002 Last Saved On: 11/22/02 2:10 PM
To Next Page
Loading...
Need help?
General
