HP VSR1000 Configuration Guide

89
Ste
p
Command Remarks
3. Enable the interface to add its
MTU into DD packets.
ospf mtu-enable
Optional.
Not enabled by default.
Configuring the maximum number of external LSAs in LSDB
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter OSPF view.
ospf [ process-id | router-id router-id |
vpn-instance vpn-instance-name ] *
N/A
3. Specify the maximum number
of external LSAs in the LSDB.
lsdb-overflow-limit number
Optional.
Not specified by
default.
Enabling compatibility with RFC 1583
RFC 1583 specifies a different method than RFC 2328 for selecting an external route from multiple LSAs.
If RFC 1583 is made compatible with RFC 2328, the routes in the backbone area are preferred; if not,
the routes in the non-backbone area are preferred to reduce the burden of the backbone area.
To avoid routing loops, HP recommends configuring all the routers to be either compatible or
incompatible with RFC 1583.
To make them compatible:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter OSPF view.
ospf [ process-id | router-id router-id |
vpn-instance vpn-instance-name ] *
N/A
3. Enable compatibility
with RFC 1583.
rfc1583 compatible
Optional.
Enabled by default.
Logging neighbor state changes
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter OSPF view.
ospf [ process-id | router-id router-id |
vpn-instance vpn-instance-name ] *
N/A
3. Enable the logging of
neighbor state changes.
log-peer-change
Optional.
Enabled by default.

HP VSR1000 Specifications

General

Model	VSR1000
Category	Network Router
Product Type	Router
Manufacturer	HP
Series	VSR
Form Factor	Rack-mountable
IPSec VPN Throughput	200 Mbps
Virtualization Support	Yes
Maximum Throughput	1 Gbps
Routing Protocols	OSPF, BGP
Virtualization Platforms	VMware
Management	Web-based management, CLI
Remote Management Protocol	SNMP, SSH, Telnet
Encryption	AES, 3DES
VPN Support	IPSec
Firewall Protection	Stateful packet inspection