HP VSR1000 Configuration Guide

77
Ste
p
Command Remarks
3. Configure the OSPF network
type for the interface as
broadcast.
ospf network-type broadcast
By default, the network type of an
interface depends on the link layer
protocol.
4. Configure a router priority for
the interface.
ospf dr-priority priority
Optional.
The default router priority is 1.
Configuring the NBMA network type for an interface
After configuring the network type of an interface as NBMA, you must make some special configurations.
Because NBMA interfaces cannot find neighbors via broadcasting hello packets, you must specify
neighbors and their router priorities. (A router priority of 0 means the router does not have the DR election
right. A router priority greater than 0 means the router has the DR election right.)
The router priority configured with the ospf dr-priority command is for actual DR election. The priority
configured with the peer command indicates whether a neighbor has the election right or not. If you
configure the router priority for a neighbor as 0, the local router will assume the neighbor has no election
right, and thus send no hello packets to this neighbor. However, if the local router is the DR or BDR, it still
sends hello packets to the neighbor with priority 0 for neighborship establishment.
To configure the OSPF network type for an Interface as NBMA:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Configure the OSPF network
type for the interface as
NBMA.
ospf network-type nbma
By default, the network type of an
interface depends on the link layer
protocol.
4. Configure a router priority
for the interface.
ospf dr-priority priority
Optional.
The default router priority is 1.
5. Exit to system view.
quit N/A
6. Enter OSPF view.
ospf [ process-id | router-id
router-id | vpn-instance
vpn-instance-name ] *
N/A
7. Specify a neighbor and its
router priority.
peer ip-address [ cost value |
dr-priority dr-priority ]
N/A
Configuring the P2MP network type for an interface
Ste
p
Command Remarks
1. Enter system view.
system-view N/A

HP VSR1000 Specifications

General

Brand	HP
Model	VSR1000
Category	Network Router
Language	English