EasyManuals Logo

HP VSR1000 Configuration Guide

HP VSR1000
453 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #344 background imageLoading...
Page #344 background image
331
To configure inbound route filtering:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view.
bgp as-number N/A
3. Enter IPv6 address family
view.
ipv6-family N/A
4. Configure inbound route
filtering.
filter-policy { acl6-number |
ipv6-prefix ipv6-prefix-name }
import
Not configured by default.
5. Apply a routing policy to
routes from an IPv6 peer or
peer group.
peer { ipv6-group-name |
ipv6-address } route-policy
route-policy-name import
Not applied by default.
6. Specify an ACL to filter routes
imported from an IPv6 peer or
peer group.
peer { ipv6-group-name |
ipv6-address } filter-policy
acl6-number import
Not specified by default.
7. Specify an AS path list to filter
routing information imported
from an IPv6 peer or peer
group.
peer { ipv6-group-name |
ipv6-address } as-path-acl
as-path-acl-number import
Not specified by default.
8. Specify an IPv6 prefix list to
filter routing information
imported from an IPv6 peer or
peer group.
peer { ipv6-group-name |
ipv6-address } ipv6-prefix
ipv6-prefix-name import
Not specified by default.
9. Specify the upper limit of
prefixes allowed to receive
from an IPv6 peer or peer
group.
peer { ipv6-group-name |
ipv6-address } route-limit limit
[ percentage ]
Optional.
Unlimited by default.
Configuring IPv6 BGP and IGP route synchronization
By default, upon receiving an IBGP route, an IPv6 BGP router checks the route’s next hop. If the next hop
is reachable, the IPv6 BGP router advertises the route to EBGP peers. If the synchronization feature is
configured, in addition to the reachability check of the next hop, the IPv6 BGP router must find an active
IGP route with the same destination network segment before it can advertise the IBGP route (use the
display ipv6 routing-table protocol command to check the IGP route state).
To configure IPv6 BGP and IGP route synchronization:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view.
bgp as-number N/A
3. Enter IPv6 address family view.
ipv6-family N/A
4. Enable route synchronization between
IPv6 BGP and IGP.
synchronization Not enabled by default.

Table of Contents

Other manuals for HP VSR1000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP VSR1000 and is the answer not in the manual?

HP VSR1000 Specifications

General IconGeneral
BrandHP
ModelVSR1000
CategoryNetwork Router
LanguageEnglish

Related product manuals