To Next Page

To Previous Page

387

[SwitchA-acl-basic-2000] rule 0 permit source any

[SwitchA-acl-basic-2000] quit

# Define a match criterion for class a to match ACL 2000.

[SwitchA] traffic classifier a

[SwitchA-classifier-a] if-match acl 2000

[SwitchA-classifier-a] quit

# Configure the action of redirecting traffic to the next hop 202.1.1.2 for behavior a.

[SwitchA] traffic behavior a

[SwitchA-behavior-a] redirect next-hop 202.1.1.2

[SwitchA-behavior-a] quit

# Associate class a with behavior a in QoS policy a.

[SwitchA] qos policy a

[SwitchA-qospolicy-a] classifier a behavior a

[SwitchA-qospolicy-a] quit

# Apply QoS policy a to the incoming traffic of GigabitEthernet 1/0/1.

[SwitchA] interface gigabitethernet 1/0/1

[SwitchA-GigabitEthernet1/0/1] qos apply policy a inbound

Verifying the configuration

After completing the configuration, verify that when Switch A receives packets with destination IP address

201.1.1.2, it forwards the packets to Switch C instead of Switch B.

IPv6 PBR configuration example (using a QoS policy)

Network requirements

As shown in Figure 126, redirect all packets received on GigabitEthernet 1/0/1 of Switch A to the next

hop 202::2.

Figure 126 Network diagram

Configuration procedure

# Configure IPv6 ACL 2000.

<SwitchA> system-view

[SwitchA] acl ipv6 number 2000

[SwitchA-acl6-basic-2000] rule 0 permit source any

[SwitchA-acl6-basic-2000] quit

# Define a match criterion for class a to match IPv6 ACL 2000.

HP VSR1000 Configuration Guide

Other manuals for HP VSR1000