72
Task Remarks
Configuring OSPF route redistribution Optional
Tuning and optimizing
OSPF networks
Configuring OSPF packet timers Optional
Specifying LSA transmission delay Optional
Specifying SPF calculation interval Optional
Specifying the LSA arrival interval Optional
Specifying the LSA generation interval Optional
Disabling interfaces from receiving and sending OSPF
packets
Optional
Configuring stub routers Optional
Configuring OSPF authentication Optional
Adding the interface MTU into DD packets Optional
Configuring the maximum number of external LSAs in LSDB Optional
Enabling compatibility with RFC 1583 Optional
Logging neighbor state changes Optional
Configuring OSPF network management Optional
Enabling message logging Optional
Enabling the advertisement and reception of opaque LSAs Optional
Configuring OSPF to give priority to receiving and processing
hello packets
Optional
Configuring the LSU transmit rate Optional
Setting the DSCP value for OSPF packets Optional
Enabling OSPF ISPF Optional
Configuring OSPF FRR Optional
Configuring OSPF
Graceful Restart
Configuring the OSPF GR Restarter Optional
Configuring the OSPF GR Helper Optional
Triggering OSPF Graceful Restart Optional
Configuring BFD for OSPF Optional
Enabling OSPF
You must enable OSPF before performing other OSPF configuration tasks.
Configuration prerequisites
Configure the link layer protocol, and IP addresses for interfaces so that neighboring nodes can reach
each other.