335
Configuration prerequisites
Before you configure IPv6 BGP timers, complete the following tasks:
• Enable IPv6.
• Configure IPv6 BGP basic functions.
Configuring IPv6 BGP timers
Ste
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view.
bgp as-number N/A
3. Enter IPv6 address family view.
ipv6-family
N/A
4. Configure IPv6 BGP timers.
• Specify keepalive interval and
holdtime:
timer keepalive keepalive hold
holdtime
• Configure keepalive interval
and holdtime for an IPv6 peer
or peer group:
peer { ipv6-group-name
|.ipv6-address } timer
keepalive keepalive hold
holdtime
Optional.
The keepalive interval defaults to
60 seconds, holdtime defaults to
180 seconds.
The holdtime interval must be at
least three times the keepalive
interval.
Timers configured by using the
timer command have lower
priority than timers configured by
using the peer timer command.
5. Configure the interval for
sending the same update to an
IPv6 peer or peer group.
peer { ipv6-group-name |
ipv6-address }
route-update-interval interval
Optional.
The interval for sending the same
update to an IBGP peer or an
EBGP peer defaults to 15
seconds or 30 seconds.
Configuring IPv6 BGP soft reset
Enabling route refresh
Ste
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view.
bgp as-number N/A
3. Enter IPv6 address
family view.
ipv6-family N/A
4. Enable route refresh.
peer { ipv6-group-name | ipv6-address }
capability-advertise route-refresh
Optional.
Enabled by default.
Performing manual soft-reset
To Next Page
Loading...
Need help?
General
