HP VSR1000 Configuration Guide

82
Ste
p
Command Remarks
2. Enter OSPF view.
ospf [ process-id | router-id router-id |
vpn-instance vpn-instance-name ] *
N/A
3. Configure the maximum
number of ECMP routes.
maximum load-balancing maximum
Optional.
8 by default.
Configuring OSPF preference
A router can run multiple routing protocols, and each protocol is assigned a preference. When the
routing protocols find routes to the same destination, the route found by the protocol with the highest
preference is selected as the best route.
To configure OSPF preference:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter OSPF view.
ospf [ process-id | router-id router-id
| vpn-instance vpn-instance-name ] *
N/A
3. Configure a
preference for OSPF.
preference [ ase ] [ route-policy
route-policy-name ] value
Optional.
By default, the preference of OSPF
internal routes is 10, and the preference
of OSPF external routes is 150.
Configuring OSPF route redistribution
This section describes configuring OSPF to redistribute manually configured routes or routes discovered
by other routing protocols.
Only active routes can be redistributed. Use the display ip routing-table protocol command to view route
state information.
Configuring route redistribution into OSPF
On a router running OSPF and other routing protocols, you can configure OSPF to redistribute routes
from other protocols such as RIP, IS-IS, BGP, static, and direct routes, and advertise them in Type-5 LSAs
or Type-7 LSAs.
By filtering redistributed routes, OSPF translates only permitted routes into Type-5 LSAs or Type-7 LSAs for
advertisement.
To configure OSPF route redistribution:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter OSPF view.
ospf [ process-id | router-id router-id |
vpn-instance vpn-instance-name ] *
N/A

HP VSR1000 Specifications

General

Brand	HP
Model	VSR1000
Category	Network Router
Language	English