EasyManuals Logo

HP VSR1000 Configuration Guide

HP VSR1000
453 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #297 background imageLoading...
Page #297 background image
284
• Using the filter-policy export command filters routes redistributed with the import-route command.
If the import-route command is not configured, executing the filter-policy export command does
not take effect.
To configure OSPFv3 route redistribution:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter OSPFv3 view.
ospfv3 [ process-id ]
N/A
3. Specify a default cost for
redistributed routes.
default cost value
Optional.
1 by default.
4. Redistribute routes from
another protocol, or another
OSPFv3 process.
import-route protocol [ process-id | allow-ibgp ]
[ cost value | route-policy route-policy-name |
type type ] *
Not configured by
default.
5. Inject a default route.
default-route-advertise [ always | cost value |
type type | route-policy route-policy-name ] *
Optional.
Not injected by
default.
6. Filter redistributed routes.
filter-policy { acl6-number | ipv6-prefix
ipv6-prefix-name } export [ isisv6 process-id |
ospfv3 process-id | ripng process-id | bgp4+ |
direct | static ]
Optional.
Not configured by
default.
Tuning and optimizing OSPFv3 networks
This section describes configurations of OSPFv3 timers, interface DR priority, MTU check ignorance for
DD packets, and disabling interfaces from sending OSPFv3 packets.
The following are OSPFv3 timers:
• Packet timer—Specified to adjust topology convergence speed and network load.
• LSA delay timer—Specified especially for low-speed links.
• SPF timer—Specified to protect networks from being overloaded due to frequent network changes.
For a broadcast network, you can configure DR priorities for interfaces to affect DR or BDR election.
After an interface is disabled from sending OSPFv3 packets, other routers cannot obtain any information
from the interface.
Configuration prerequisites
Before you tune and optimize OSPFv3 networks, complete the following tasks:
• Enable IPv6 packet forwarding.
• Configure OSPFv3 basic functions.
Configuring OSPFv3 timers
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A

Table of Contents

Other manuals for HP VSR1000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP VSR1000 and is the answer not in the manual?

HP VSR1000 Specifications

General IconGeneral
BrandHP
ModelVSR1000
CategoryNetwork Router
LanguageEnglish

Related product manuals