HP VSR1000 Configuration Guide

325
Task Remarks
Configuring BFD for IPv6 BGP Optional
Configuring IPv6 BGP basic functions
Configuration prerequisites
Before you configure IPv6 BGP basic functions, complete the following tasks:
• Specify IP addresses for interfaces.
• Enable IPv6 with the ipv6 command in system view.
Configuration guidelines
Create a peer group before configuring basic functions for it. For more information, see "Configuring
IPv6 BGP peer group."
Specifying an IPv6 BGP peer
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view.
bgp as-number N/A
3. Specify a router ID.
router-id router-id
Optional.
Required if no IP addresses are
configured for any interfaces.
4. Enter IPv6 address family
view.
ipv6-family N/A
5. Specify an IPv6 peer.
peer ipv6-address as-number
as-number
N/A
Injecting a local IPv6 route
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view.
bgp as-number N/A
3. Enter IPv6 address family
view.
ipv6-family N/A
4. Inject a local route into the
IPv6 BGP routing table.
network ipv6-address prefix-length
[ short-cut | route-policy
route-policy-name ]
Not added by default.

HP VSR1000 Specifications

General

Brand	HP
Model	VSR1000
Category	Network Router
Language	English