HP VSR1000 Configuration Guide

339
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view.
bgp as-number N/A
3. Enter IPv6 address family
view.
ipv6-family N/A
4. Enable MD5 authentication
when establishing a TCP
connection to the peer or peer
group.
peer { ipv6-group-name |
ipv6-address } password { cipher |
simple } password
Not enabled by default.
Applying an IPsec policy to an IPv6 BGP peer or peer group
To protect routing information and defend attacks, IPv6 BGP can authenticate protocol packets by using
an IPsec policy.
Outbound IPv6 BGP packets carry the Security Parameter Index (SPI) defined in the IPsec policy. A device
uses the SPI carried in a received packet to match against the configured IPsec policy. If they match, the
device accepts the packet; otherwise, it discards the packet and will not establish a neighbor relationship
with the sending device.
Configuration prerequisites
Before you apply an IPsec policy to a peer or peer group, complete following tasks:
• Create an IPsec proposal.
• Create an IPsec policy.
For more information about IPsec policy configuration, see Security Configuration Guide.
Configuration guidelines
An IPsec policy used for IPv6 BGP can be only in manual mode. For more information, see Security
Configuration Guide.
Configuration procedure
To apply an IPsec policy to a peer or peer group
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view.
bgp as-number N/A
3. Enter IPv6 address
family view.
ipv6-family N/A
4. Apply an IPsec policy to
a peer or peer group.
peer { group-name | ip-address } ipsec-policy
policy-name
Not configured by default.

HP VSR1000 Specifications

General

Brand	HP
Model	VSR1000
Category	Network Router
Language	English