HP VSR1000 Configuration Guide

328
Ste
p
Command Remarks
3. Enter IPv6 address family view.
ipv6-family N/A
4. Disable session establishment to an
IPv6 peer or peer group.
peer { ipv6-group-name |
ipv6-address } ignore
Optional.
Not disabled by default.
Logging IPv6 peer or peer group state changes
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view.
bgp as-number N/A
3. Enable logging of peer
changes globally.
log-peer-change
Optional.
Enabled by default.
For information about the
log-peer-change command, see
Layer 3—IP Routing Command
Reference.
4. Enter IPv6 address family
view.
ipv6-family N/A
5. Enable the state change
logging for an IPv6 peer or
peer group.
peer { ipv6-group-name |
ipv6-address } log-change
Optional.
Enabled by default.
Controlling route distribution and reception
This task includes routing information filtering, routing policy application, and route dampening.
Configuration prerequisites
Before you configure route distribution and reception control, complete the following tasks:
• Enable IPv6.
• Configure IPv6 BGP basic functions.
Configuring IPv6 BGP route redistribution
To configure IPv6 BGP route redistribution:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view.
bgp as-number N/A
3. Enter IPv6 address family view.
ipv6-family N/A

HP VSR1000 Specifications

General

Brand	HP
Model	VSR1000
Category	Network Router
Language	English