EasyManuals Logo

HP VSR1000 Configuration Guide

HP VSR1000
453 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #237 background imageLoading...
Page #237 background image
224
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enable BGP and enter its view.
bgp as-number N/A
3. Enable GR Capability for BGP.
graceful-restart Disabled by default.
4. Configure the maximum time
allowed for the peer to
reestablish a BGP session.
graceful-restart timer restart
timer
Optional.
150 seconds by default.
5. Configure the maximum time to
wait for the End-of-RIB marker.
graceful-restart timer
wait-for-rib timer
Optional.
180 seconds by default.
Enabling trap
After trap is enabled for BGP, BGP generates Level-4 traps to report important events. The generated
traps are sent to the information center of the device. The trap output rules (whether to output the traps
and the output direction) are determined according to the information center configuration. (For
information center configuration, see Network Management and Monitoring Configuration Guide.)
To enable trap:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enable trap for BGP.
snmp-agent trap enable bgp
Optional.
Enabled by default.
Enabling logging of peer state changes
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view.
bgp as-number N/A
3. Enable the logging of peer
state changes globally.
log-peer-change
Optional.
Enabled by default.
4. Enable the logging of peer
state changes for a peer or
peer group.
peer { group-name | ip-address }
log-change
Optional.
Enabled by default.
Configuring BFD for BGP
BGP maintains neighbor relationships based on the keepalive timer and holdtime timer, which are set in
seconds. BGP defines that the holdtime interval must be at least three times the keepalive interval. This
slows down link failure detection; once a failure occurs on a high-speed link, a large quantity of packets
will be dropped. BFD is introduced to solve this problem. It detects links between neighbors quickly to
reduce convergence time upon link failures.

Table of Contents

Other manuals for HP VSR1000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP VSR1000 and is the answer not in the manual?

HP VSR1000 Specifications

General IconGeneral
BrandHP
ModelVSR1000
CategoryNetwork Router
LanguageEnglish

Related product manuals