HP VSR1000 Configuration Guide

382
Displaying and maintaining PBR configuration
PBR configuration (using a PBR policy)
Task Command Remarks
Display the PBR routing
information.
display ip policy-based-route [ | { begin |
exclude | include } regular-expression ]
Available in any view
Display the specified PBR routing
information.
display ip policy-based-route setup
{ interface interface-type interface-number |
local | policy-name } [ | { begin | exclude |
include } regular-expression ]
Available in any view
Display PBR statistics.
display ip policy-based-route statistics
{ interface interface-type interface-number |
local } [ | { begin | exclude | include }
regular-expression ]
Available in any view
Display the PBR policy information.
display policy-based-route [ policy-name ]
[ | { begin | exclude | include }
regular-expression ]
Available in any view
Clear PBR statistics.
reset policy-based-route statistics
[ policy-name ]
Available in user view
If a policy has a node with no if-match or apply clause configured, all packets can pass the policy.
However, no action is taken and the packets will not go to the next policy node for a match. The statistics
of PBR will be changed.
If a policy node has if-match clauses, but no apply clauses configured, packets will match against these
if-match clauses. However, no apply clauses are applicable to the permitted packets, and the packets
will not go to the next policy node for a match. The statistics of PBR will be changed.
If a policy node has no if-match clause, but apply clauses configured, all packets can pass the policy,
and then are forwarded according to the apply clauses if the permit keyword is specified for the node,
or are denied if the deny keyword is specified. The packets will not go to the next policy node for a match.
The statistics of PBR will be changed.
If the match mode of a policy node is deny, no apply clause will be executed for the packets satisfying
all the if-match clauses, and the packets will not go to the next policy node for a match. They will be
forwarded according to the routing table instead. Neither debugging information nor statistics for the
deny match mode can be displayed.
PBR configuration (using a QoS policy)
Task Command Remarks
Display user-defined QoS policy
configuration information.
display qos policy user-defined [ policy-name
[ classifier tcl-name ] ] [ | { begin | exclude |
include } regular-expression ]
Available in
any view
Display QoS policy configuration on
the specified interface or on all
interfaces.
display qos policy interface [ interface-type
interface-number ] [ inbound | outbound ] [ | { begin
| exclude | include } regular-expression ]
Available in
any view

HP VSR1000 Specifications

General

Brand	HP
Model	VSR1000
Category	Network Router
Language	English