HP VSR1000 Configuration Guide

287
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter OSPFv3 view.
ospfv3 [ process-id ] N/A
3. Enable the logging of
neighbor state changes.
log-peer-change Enabled by default.
Configuring OSPFv3 GR
IMPORTANT:
You cannot confi
g
ure OSPFv3 GR after confi
g
urin
g
OSPFv3 virtual links, because they are not supported
at the same time.
Graceful Restart ensures the continuity of packet forwarding when a routing protocol restarts or a
master/slave switchover occurs:
• GR Restarter—Graceful restarting router. It must be Graceful Restart capable.
• GR Helper—The neighbor of the GR Restarter. It helps the GR Restarter to complete the GR process.
To prevent service interruption after a master/slave switchover, a GR Restarter running OSPFv3 must
complete the following tasks:
• Keep the GR Restarter forwarding entries stable during reboot.
• Establish all adjacencies and obtain complete topology information after reboot.
After the master/slave switchover, the GR Restarter sends a Grace-LSA to tell its neighbors that it performs
a GR. Upon receiving the Grace-LSA, the neighbors with the GR Helper capability enter the helper mode
(and are then called "GR Helpers"). Then, the GR Restarter retrieves its adjacencies and LSDB with the
help of the GR Helpers.
Configuring GR Restarter
You can configure the GR Restarter capability on a GR Restarter.
To configure GR Restarter:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter OSPFv3 view.
ospfv3 [ process-id ] N/A
3. Enable the GR
capability.
graceful-restart enable Disabled by default.
4. Configure the GR
interval.
graceful-restart interval
interval-value
Optional.
120 seconds by default.
Configuring GR Helper
You can configure the GR Helper capability on a GR Helper.
To configure GR Helper

HP VSR1000 Specifications

General

Brand	HP
Model	VSR1000
Category	Network Router
Language	English