EasyManuals Logo

HP VSR1000 Configuration Guide

HP VSR1000
453 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #411 background imageLoading...
Page #411 background image
398
Configuring routing between MCE and VPN site
Configuring static routing between MCE and VPN site
An MCE can reach a VPN site through a static route. Static routing on a traditional CE is globally
effective and thus does not support address overlapping among VPNs. An MCE supports binding a static
route with a VPN instance, so that the static routes of different VPN instances can be isolated from each
other.
To configure static routing between MCE and VPN site:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Configure a static route
for a VPN instance.
• ip route-static dest-address { mask | mask-length }
{ gateway-address | interface-type
interface-number [ gateway-address ] |
vpn-instance d-vpn-instance-name
gateway-address } [ preference preference-value ]
[ tag tag-value ] [ description description-text ]
• ip route-static vpn-instance
s-vpn-instance-name&<1-6> dest-address { mask |
mask-length } { gateway-address [ public ] |
interface-type interface-number
[ gateway-address ] | vpn-instance
d-vpn-instance-name gateway-address }
[ preference preference-value ] [ tag tag-value ]
[ description description-text ]
Use either command.
Perform this
configuration on the
MCE. On a VPN site,
configure a normal
static route.
3. Configure the default
precedence for static
routes.
ip route-static default-preference
default-preference-value
Optional.
60 by default.
Configuring RIP between MCE and VPN site
A RIP process belongs to the public network or a single VPN instance. If you create a RIP process without
binding it to a VPN instance, the process belongs to the public network. By configuring RIP
process-to-VPN instance bindings on a IPv6 MCE, you allow routes of different VPNs to be exchanged
between the MCE and the sites through different RIP processes, ensuring the separation and security of
VPN routes.
For more information about RIP, see Layer 3—IP Routing Configuration Guide.
To configure RIP between MCE and VPN site:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Create a RIP process for a
VPN instance and enter RIP
view.
rip [ process-id ] vpn-instance
vpn-instance-name
Perform this configuration on the
MCE. On a VPN site, create a
normal RIP process.
3. Enable RIP on the interface
attached to the specified
network.
network network-address
By default, RIP is disabled on an
interface.

Table of Contents

Other manuals for HP VSR1000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP VSR1000 and is the answer not in the manual?

HP VSR1000 Specifications

General IconGeneral
BrandHP
ModelVSR1000
CategoryNetwork Router
LanguageEnglish

Related product manuals