EasyManuals Logo

HP VSR1000 Configuration Guide

HP VSR1000
453 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #30 background imageLoading...
Page #30 background image
17
# Display the BFD session information on Switch A.
<SwitchA> display bfd session
Total Session Num: 1 Init Mode: Active
Session Working Under Ctrl Mode:
LD/RD SourceAddr DestAddr State Holdtime Interface
4/7 12.1.1.1 12.1.1.2 Up 2000ms Vlan10
The output shows that the BFD session has been created.
# Display static routes on Switch A.
<SwitchA> display ip routing-table protocol static
Public Routing Table : Static
Summary Count : 2
Static Routing table Status : <Active>
Summary Count : 1
Destination/Mask Proto Pre Cost NextHop Interface
120.1.1.0/24 Static 60 0 12.1.1.2 Vlan10
Direct Routing table Status : <Inactive>
Summary Count : 1
Destination/Mask Proto Pre Cost NextHop Interface
120.1.1.0/24 Static 65 0 10.1.1.100 Vlan11
The output shows that Switch A communicates with Switch B through VLAN-interface 10.
When the link over VLAN-interface 10 fails, Switch A can quickly detect the failure.
# Display static routes information on Switch A again.
<SwitchA> display ip routing-table protocol static
Public Routing Table : Static
Summary Count : 1
Static Routing table Status : <Active>
Summary Count : 1
Destination/Mask Proto Pre Cost NextHop Interface
120.1.1.0/24 Static 65 0 10.1.1.100 Vlan11
Static Routing table Status : <Inactive>
Summary Count : 0
The output shows that Switch A communicates with Switch B through VLAN-interface 11 now.
BFD for static routes configuration example (indirect next hop)
Network requirements
As shown in Figure 5, Switch A has a route to interface Loopback 1 (2.2.2.9/32) on Switch B, with output
interface VLAN-interface 10. Switch B has a route to interface Loopback 1 (1.1.1.9/32) on Switch A, with
output interface VLAN-interface 12. Switch D has a route to 1.1.1.9/32, with output interface
VLAN-interface 10, and a route to 2.2.2.9/32, with output interface VLAN-interface 12.
Configure static routes to subnet 120.1.1.0/24 on Switch A, static routes to subnet 121.1.1.0/24 on Switch
B, and static routes to subnets 120.1.1.0/24 and 121.1.1.0/24 on both Switch C and Switch D. Enable BFD

Table of Contents

Other manuals for HP VSR1000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP VSR1000 and is the answer not in the manual?

HP VSR1000 Specifications

General IconGeneral
BrandHP
ModelVSR1000
CategoryNetwork Router
LanguageEnglish

Related product manuals